In the majority of situations, most people spend quite a bit of money buying their lift truck. Thus, it is really essential to take proper care of it so as to protect your investment well into the long run. It is really a good idea to know the procedures that are carried out in the maintenance and care of this piece of machine.
One of the best ways to tell how good the engine is working is by starting the forklift up and listening carefully to see how it runs. For instance, if there are any misses or knocks, the machinery is defective and this must raise several concerns. Additionally listen carefully for any squealing noise that come from the belts since these noises will provide you with a lot of information.
Some of the main components needing attention during maintenance consist of the safety warning devices, gauges, horn, the lights and the overhead guard. Any burnt out light bulbs or faulty parts need to be replaced as soon as they are noticed. It is also vital to inspect the wiring.
The battery compartment terminals should be cleaned when the above parts have been checked carefully. If the terminals are not clean, be sure to clean them properly. Every cell of the battery should be inspected so as to ensure the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machinery and then change the filters. The fuel filters, hydraulic filter and the transmission filter need to be replaced on a regular basis. Before fitting them, be sure to write the date on the new filters by using a permanent marker to be able to keep track.
After the oil change is finished and the filters have been replaced, a visual inspection of the drive axle has to be performed. If there is a grease fitting on the axle make certain to apply some grease. Inspect the belts on the engine for any cracks or frays. If you find any, fix the issue accordingly. Afterwards, check each and every other part of the machine like the wheels. If any type of concern or fault is detected, be certain to address it immediately in order to make certain the machinery is running at its safest and optimum levels.